درباره ما
Browsing TIA - Telecommunications Industry Association by Issue Date
Now showing items 1-20 of 1186
-
TIA RS-210
Abstract: INTRODUCTION
The standards included in Part 1 are for Terminating and Signaling equipment to be used in Telephone Service. Subsequent parts will cover such services as Data Transmission, Remote Control, ... -
TIA 384
Abstract: INTRODUCTION AND SCOPE
The standards contained in this document are intended to be used as performance and interface criteria. As such, these standards may find a typical application in the layout of ... -
TIA LEB 2
Abstract: Foreword
This bulletin was developed by the EIA Laser Subdivision Government Liaison Ad Hoc Committee with principal inputs from mmbenss of the Laser Safety (L-1) committee and the Laser Standards (L-2) Committee, ... -
TIA 252-A
Abstract: INTRODUCTION AND SCOPE
This standard applies to microwave relay communication systems. Usually these systems are multi-hop. They transmit intelligence initially derived from speech, telegraph, data, ... -
TIA LEB 3
Abstract: Foreword
The central purposes of this EIA Engineering Bulletin are:
a.) to provide interpretation of the language and intent of the BRH Guide for Submission of Information on Lasers and Products Containing Lasers ... -
TIA RS-442
Abstract: SCOPE AND REQUIREMENTS
The below listed charts is based on following: The original FCC channel number assignments remain unchanged (1 through 23); 27.435 MHz is now channel 24; 27.245 MHz is now channel ... -
TIA IEB13
Abstract: INTRODUCTION
The purpose of this bulletin is to establish a uniform format for submission of technical data in conjunction with FCC type acceptance of Citizens Band radios.
A type acceptance filing should consist ... -
TIA EIA-424
Abstract: This Standard details definitions and methods of measurement of characteristics of SSB transmitters and receivers or SSB/AM transmitters and receivers, operating in the SSB mode, intended for operation in the Class "D" ... -
TIA TIA/EIA-5090000
Abstract: This EIA Recommended Standard, which is a Generic Specification, relates to fiber optic terminating devices such that a complete fiber optic transmission link may be interchanged with alternative transmission media and ... -
TIA TIA-455-172
Abstract: 1.0 INTENT
This procedure provides for a test to determine the ability of a cabled and mated connector (plug and receptacle) to resist firewall environments, such as flame or ignition of gases. Optical operation is ... -
TIA EIA-411-A
Abstract: PREFACE
The objectives of EIA-411-A, Electrical and Mechanical Characteristics of Earth Station Antennas for Satellite Communications," are the following:
(a) to provide standard terms, definitions, ... -
TIA EIA/TIA/IS-63
Abstract: General
This standard specifies a procedure for a modem to automatically detect the modulation technique and data signalling rate of the modem it is connected with. When incorporated into a new modem, ... -
TIA TIA-574
Abstract: GENERAL
This Standard is applicable to the interconnection of data terminating equipment (DTE) and data circuit-terminating equipment (DCE) employing serial binary data interchange where a minimal ... -
TIA TIA-455-187
Abstract: INTRODUCTION
Intent
The purpose of this procedure is to measure the forces or torques that are required to fully couple or uncouple a connector set.
Description ... -
TIA TIA-455-186
Abstract: INTRODUCTION
Intent
This procedure is used to measure the retention characteristics of the resilient member of a fiber optic component (most commonly a connector). It is specifically ... -
TIA TIA-526
Abstract: INTRODUCTION
This document, together with its addenda, provides uniform test procedures for testing all or part of fiber optic systems or subsystems intended for optical communications and data ...